Suction and delivery Hoses
Suction Hoses
These hoses are made from wear resistand material and reinforced by steel or PVC spiral in order to resist vacuum on the suction end.
Amazone
Plasticized super elastic PVC hose reinforced by a rigid PVC spiral (anti shock).
- Diameter: 20 – 200 mm
- Working pressure: 1.5 to 6 bar
- Vacuum: -0.8 to -1 bar
- Temperature range: -20° till 60°C
Application: Suction and discharge for used water, especially as equipment for trucks
Metalflex
Plasticized super elastic PVC hose reinforced by steel spiral.
- Diameter: 8 – 150 mm
- Working pressure: 1.5 to 5 bar
- Vacuum: -0.9 bar
- Temperature range: -10° till 60°C
Application: Suction and discharge at low pressure for public work, agriculture, pumps
WSD
Mandrel built suction & delivery hose for water and non corrosive fluids.
- Diameter: 20 – 300 mm
- Working pressure: 10 bar
- Vacuum: -0.7 to -0.9 bar
- Temperature range: -30°C till +80°C
Application: Water and inert fluid suction & delivery with optimal flexibility and strength
Discharge hoses
The most most cost-efficient way for water discharge is to use soft PVC flat hoses. These hoses can be easily rolled and installed in the necessary place. For diameters over 150mm it is recommended to use reinforced rubber hoses.
Lay flat
Plasticized PVC lay flat hose reinforced by polyester thread, possibility to roll up if flat.
- Diameter: 25 – 150 mm
- Working pressure: 2 to 3 bar
- Temperature range: -10° till 60°C
Application: Discharge of water at low pressures
Firefighting
Flat one-pieced hose. Inside – black synthetic rubber, outside – polyamide tissue.
- Diameter: 38 – 150 mm
- Working pressure: 15 bar
- Temperature range: -10° till 60°C
Application: Discharge of water under high pressure
WD
Mandrel built delivery hose for water and non corrosive fluids.
- Diameter: 13 – 254 mm
- Working pressure: 10 bar
- Temperature range: -30°C till +80°C
Application: Water and inert fluid delivery hose with optimal flexibility and strength
